Replace wiper blades and top up washer fluidHow to replace wiper blades and top up washer fluid
- 15minutes
- 7steps
- 4needed
All steps
Step 1 of 7: Get the right blades
Check the sizes in the manual or a parts shop's lookup, or measure the old blades. The driver's and passenger's blades are often different lengths.
Step 2 of 7: Lift the wiper arm
Pull the arm away from the windscreen until it stays up. Some cars need the wipers in a service position first; the manual shows how.
Warning: Lay a folded towel on the glass. If the bare arm snaps back, it can crack the windscreen.
Step 3 of 7: Take off the old blade
Press the tab or clip where the blade meets the arm, then slide the blade down and off the hook. The new blade's packet shows your fitting.
Step 4 of 7: Fit the new blade
Slide it onto the arm until it clicks into place. Tug it gently to check it's secure, then lower the arm onto the glass slowly.
Step 5 of 7: Find the washer fluid tank
Open the bonnet. The washer tank's cap shows a windscreen with a spray of water, and is often blue.
Warning: Check the symbol before you pour. Coolant, brake fluid and oil each have their own cap.
Step 6 of 7: Top it up
Pour in screenwash, mixed as the bottle says, until the level reaches the neck. In winter, use one rated for freezing temperatures.
Warning: Not washing-up liquid: it leaves smears. Not plain water in winter: it can freeze.
Step 7 of 7: Test them
Switch on the ignition and run the wipers with a spray of washer fluid. They should wipe clean in one pass, without streaks, skipping or squeaking.
Streak-Free
Tap the steps in the right order with no mistakes to earn this title and finish the skill.
Start the drillYour levels for this skill