Check and top up engine oilHow to check and top up engine oil
- 10minutes
- 7steps
- 4needed
All steps
Step 1 of 7: Park on level ground and wait
Park on flat ground and switch the engine off. Wait at least 5 minutes so the oil drains back down and the engine cools a little.
Warning: Parts of the engine stay hot after driving. Touch only the dipstick and filler cap handles.
Step 2 of 7: Find the dipstick
Open the bonnet. The dipstick usually has a bright yellow or orange loop handle. The manual shows where it is.
Step 3 of 7: Pull it out, wipe it, put it back
Pull the dipstick out, wipe it clean with a cloth, then push it all the way back in.
Step 4 of 7: Read the level
Pull it out again and look at the tip. The oil should be between the minimum and maximum marks. Then push the dipstick back in.
Step 5 of 7: Add oil if it's low
Unscrew the oil filler cap on top of the engine; it has an oil-can symbol. Pour in a little at a time, no more than half a litre, using the oil your manual specifies.
Warning: Check the cap before you pour. Coolant, brake fluid and washer fluid each have their own cap.
Step 6 of 7: Wait and check again
Wait a minute for the oil to settle, then check the dipstick again. Repeat until the level is near the maximum mark, but not above it.
Warning: Too much oil can damage the engine. If you overfill, have it drained to the right level.
Step 7 of 7: Close up
Screw the filler cap on firmly, push the dipstick fully in and close the bonnet. Wipe up any spills. If you need to top up often, get the car checked.
Dipstick Detective
Tap the steps in the right order with no mistakes to earn this title and finish the skill.
Start the drillYour levels for this skill