Change a flat tyreHow to change a flat tyre
- 20minutes
- 8steps
- 4needed
All steps
Step 1 of 8: Stop somewhere safe
Pull over on flat, firm ground, well away from traffic. Hazard lights on, handbrake on, and leave it in first gear or Park. Get everyone out and away from the road.
Warning: On a motorway or a fast road, don't change it yourself. Stand behind the barrier and call for help.
Step 2 of 8: Get out the spare and tools
Take out the spare wheel, the jack and the wheel wrench, plus the locking wheel nut key if your car has one. Press the spare's tyre; it should feel firm.
Step 3 of 8: Loosen the nuts a little
Take off any hub cap. With the wheel still on the ground, turn each nut anticlockwise about half a turn. Don't remove them yet. If one is stiff, push down on the wrench with your foot.
Step 4 of 8: Jack up the car
Put the jack under the jacking point nearest the flat; the manual shows where, often a notch on the sill. Raise the car until the tyre is about 5 cm off the ground.
Warning: Never put any part of your body under a car held up only by a jack.
Step 5 of 8: Take off the flat wheel
Unscrew the nuts and keep them together where they can't roll away. Pull the wheel straight towards you and lay it flat on the ground.
Step 6 of 8: Fit the spare
Lift the spare onto the studs, or line up its bolt holes with the hub. Screw every nut back on by hand, then snug them with the wrench.
Step 7 of 8: Lower the car and tighten
Lower the car until the tyre takes its weight, then remove the jack. Tighten the nuts firmly in a criss-cross order, going round twice.
Step 8 of 8: Pack up and drive carefully
Stow the flat, jack and tools. A space-saver spare has a speed limit, often 50 mph (80 km/h): check its sidewall. Get the nuts re-checked and the flat repaired soon.
Pit Crew
Tap the steps in the right order with no mistakes to earn this title and finish the skill.
Start the drillYour levels for this skill