Jump-start a carHow to jump-start a car
- 10minutes
- 7steps
- 3needed
All steps
Step 1 of 7: Get both cars ready
Park them close enough for the cables to reach, but not touching. Both engines off, handbrakes on, lights and radio off.
Step 2 of 7: Red clamp on the dead battery +
Clip one red clamp to the positive (+) terminal of the dead battery. It often has a red cover.
Warning: From now on, never let the metal clamps touch each other.
Step 3 of 7: Other red clamp on the donor +
Clip the other end of the red cable to the positive (+) terminal of the working battery.
Step 4 of 7: Black clamp on the donor −
Clip one black clamp to the negative (−) terminal of the working battery.
Step 5 of 7: Last black clamp on bare metal
On the dead car, clip the last black clamp to an unpainted metal bolt or bracket on the engine, away from the battery.
Warning: Not on the dead battery itself: the last clamp can spark, and batteries give off flammable gas.
Step 6 of 7: Start the donor, then the dead car
Run the working car for 2 to 3 minutes, then try starting the dead one. If it does not start, wait a few more minutes and try again.
Step 7 of 7: Remove the cables in reverse order
Take them off 4, 3, 2, 1. Then drive for 20 to 30 minutes so the battery recharges.
Warning: If it dies again soon, the battery or alternator needs checking.
The Spark
Tap the steps in the right order with no mistakes to earn this title and finish the skill.
Start the drillYour levels for this skill