Make a fireHow to build and light a campfire safely
- 15minutes
- 8steps
- 5needed
All steps
Step 1 of 8: Pick a safe spot
Use an existing fire ring if there is one. Otherwise choose bare, flat ground at least 5 metres from tents, trees, overhanging branches and dry grass.
Warning: Have your water or sand within reach before you light anything.
Step 2 of 8: Clear and ring the spot
Scrape away leaves and twigs down to bare soil in a circle about 3 metres across. Ring the middle with dry stones if you have them.
Warning: Don't use stones from a river or lake: trapped water can make them crack or burst in the heat.
Step 3 of 8: Make a tinder bundle
Place a loose, fist-sized bundle of tinder in the middle of the ring. Keep it loose so air can get in.
Step 4 of 8: Lean kindling over it
Lean small, dry sticks around the tinder in a cone. Leave a gap on the side the wind comes from, so you can reach in to light it.
Step 5 of 8: Light the tinder
Crouch with your back to the wind and light the tinder low down, through the gap. If the flame struggles, blow gently at its base.
Step 6 of 8: Add fuel slowly
Once the kindling burns well, add bigger pieces one or two at a time. Keep the fire small; knee height is plenty.
Warning: Never use petrol or any other fuel to start or revive a fire.
Step 7 of 8: Never leave it alone
Someone must watch the fire the whole time it burns. Keep children and pets a step back, and let it burn down well before you plan to leave.
Step 8 of 8: Put it out completely
Drown the fire with water, stir the ashes with a stick, then drown it again. It's out only when you can hold your hand just above the ashes and feel no heat.
Warning: No water? Stir in sand or soil until it's cold. Never just bury a fire: it can smoulder for hours.
Firestarter
Tap the steps in the right order with no mistakes to earn this title and finish the skill.
Start the drillYour levels for this skill